Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
189Operating Manual 1176.7649.02 ─ 04
Parameters:
<Analysis> FBURst
The format of the first valid PPDU is detected and subsequent
PPDUs are analyzed only if they have the same format (corre-
sponds to "Auto, same type as first PPDU")
ALL
All PPDUs are analyzed regardless of their format (corresponds
to "Auto, individually for each PPDU")
MNHT
Only PPDUs with format "Non-HT" are analyzed
(IEEE 802.11 a)
DNHT
All PPDUs are assumed to have the PPDU format "Non-HT"
(IEEE 802.11 a)
MMIX
Only PPDUs with format "HT-MF" (Mixed) are analyzed
(IEEE 802.11 n)
MGRF
Only PPDUs with format "HT-GF" (Greenfield) are analyzed
(IEEE 802.11 n)
DMIX
All PPDUs are assumed to have the PPDU format "HT-MF"
(IEEE 802.11 n)
DGRF
All PPDUs are assumed to have the PPDU format "HT-GF"
(IEEE 802.11 n)
MVHT
Only PPDUs with format "VHT" are analyzed
(IEEE 802.11 ac)
DVHT
All PPDUs are assumed to have the PPDU format "VHT"
(IEEE 802.11 ac)
*RST:
FBURst
Example:
SENS:DEM:FOR:BAN:BTYP:AUTO:TYPE FBUR
Mode: WLAN
Manual operation: See "PPDU format to measure" on page 104
[SENSe:]DEMod:FORMat:BANalyze:DBYTes:EQUal <State>
When this command is set to ON then only bursts of equal length will take part in the
measurement analysis. The number of data bytes that a burst must have in order to
take part in measurement analysis is specified by the [SENSe:]DEMod:FORMat:
BANalyze:DBYTes:MIN on page 190 command.
SENSe Subsystem (WLAN)