Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
187Operating Manual 1176.7649.02 ─ 04
[SENSe:]DEMod:FILTer:MODulation <TXFilter>, <RXFilter>
This command selects the TX and RX filters. The names of the filters correspond to the
file names; a query of all available filters is possible by means of the [SENSe:
]DEMod:FILTer:CATalog? on page 186 command.
Parameters:
<TXFilter>,
<RXFilter>
*RST: AUTO,AUTO
DEF_TX: default transmit filter, DEF_RX: default receive filter
Example:
DEM:FILT:MOD 'DEF_TX','DEF_RX'
DEF_TX is selected for the TX filter and DEF_RX for the RX fil-
ter
Mode: WLAN
Manual operation: See "Transmit Filter" on page 103
See "Receive Filter" on page 103
[SENSe:
]DEMod:FORMat:BANalyze <Format>
The remote control command sets the analysis modulation format that will be assumed
when the measurement is performed. If the [SENSe:]DEMod:FORMat:SIGSymbol
on page 196 parameter has been set to ON, this command can be used to measure
only certain burst types within a measurement sequence.
For IEEE 802.11n this command is only supported for SISO. For IEEE 802.11n
(MIMO) use: [SENSe:]DEMod:FORMat:MCSIndex on page 194:
Parameters:
<Format> *RST: QAM64
For details refer to chapter 5.14.2, "Commands of the SENSe
Subsystem", on page 182.
Example:
DEM:FORM:BAN 'QAM16'
Only bursts that are of the QAM16 modulation format are ana-
lyzed.
Mode: WLAN
Manual operation: See "Analyze PSDU Mod (IEEE 802.11n, SISO)" on page 99
See "Demodulator (IEEE 802.11a, b, g, j, p)" on page 100
[SENSe:]DEMod:FORMat:BANalyze:BTYPe <BurstType>
This remote control command specifies the type of burst to be analyzed. Only bursts of
the specified type take part in measurement analysis.
SENSe Subsystem (WLAN)