Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
185Operating Manual 1176.7649.02 ─ 04
Manual operation: See "Filter adjacent channels (IEEE 802.11ac, n (MIMO))"
on page 102
[SENSe:]BURSt:COUNt <NoOfBursts>
This command defines the number of bursts that will be analyzed by the measurement.
This parameter is ignored if the setting for the [SENSe:]BURSt:COUNt:STATe
on page 185 parameter is off.
Parameters:
<NoOfBursts> *RST: 1
Example:
BURS:COUN 16
Sets the number of bursts to 16.
Mode: WLAN
Manual operation: See "Analyze PPDUs " on page 89
[SENSe:
]BURSt:COUNt:STATe <State>
When this command is set to on, the burst count parameter will be used by the mea-
surement, otherwise the burst count parameter will be ignored.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
BURS:COUN:STAT ON
Sets the burst count state to ON
Mode: WLAN
Manual operation: See "PPDU Count " on page 89
[SENSe:]DEMod:CESTimation <State>
This command defines whether channel estimation will be done in preamble and pay-
load (if set to 1) or only in preamble (if set to 0). The effect of this is most noticeable for
the EVM measurement results, where the results will be improved when this feature is
enabled.
However, this functionality is not supported by the IEEE 802.11 standard and must be
disabled if the results are to be strictly measured against the standard.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
DEMod:CEST ON
Specifies that the IQ measurement results will use channel esti-
mation in preamble & payload.
Mode: WLAN
SENSe Subsystem (WLAN)