Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
184Operating Manual 1176.7649.02 ─ 04
Parameters:
<parameter> FBURst
The channel bandwidth of the first valid bursts is detected and
subsequent bursts are analyzed only if they have the same
channel bandwidth.
ALL
All bursts are analyzed regardless of their channel bandwidth
MB20
Only bursts with a channel bandwidth of 20MHzare analyzed
MB40
Only PPDUs within a channel bandwidth of 40MHz are analyzed
(IEEE 802.11 n, ac only)
MB80
Only PPDUs within a channel bandwidth of 80MHz are analyzed
(IEEE 802.11 ac only)
MB160
Only PPDUs within a channel bandwidth of 160MHz are ana-
lyzed
(IEEE 802.11 ac only)
DB20
All bursts are analyzed according to a channel bandwidth of
20MHz
DB40
All PPDUs are analyzed within a channel bandwidth of 40MHz
(IEEE 802.11 n, ac only)
DB80
All PPDUs are analyzed within a channel bandwidth of 80MHz
(IEEE 802.11 n, ac only)
DB160
All PPDUs are analyzed within a channel bandwidth of 160MHz
(IEEE 802.11 n, ac only)
*RST:
FBURst
Example:
SENS:BAND:CHAN:AUTO:TYPE ALL
Mode: WLAN
Manual operation: See "Channel Bandwidth to measure" on page 105
[SENSe:]BANDwidth[:RESolution]:FILTer <State>
This remote control command enables or disables use of the RBW filter
Parameters:
<State> ON | OFF
*RST: OFF
Example:
SENS:BAND:RES:FILT ON
Mode: WLAN
SENSe Subsystem (WLAN)