Service manual

Remote Commands for WLAN TX Measurements

R&S

FSV-K91/91n/91ac/91p

180Operating Manual 1176.7649.02 ─ 04

MMEMory:LOAD:IQ:STATe............................................................................................ 180

MMEMory:LOAD:SEM:STATe 1,..................................................................................... 180

MMEMory:STORe:IQ:STATe.......................................................................................... 180

MMEMory:LOAD:IQ:STATe 1, <FileName>

This command loads the I/Q data from the specified .iqw file.

Parameters:

Example:

MMEM:LOAD:IQ:STAT 1, 'C:

\R_S\Instr\user\data.iqw'

Loads IQ data from the specified file.

Usage: Setting only

Mode: WLAN

Manual operation: See "Import" on page 68

MMEMory:LOAD:SEM:STATe 1, <FileName>

This command loads a spectrum emission mask setup from an xml file.

Parameters:

Example:

MMEM:LOAD:SEM:STAT 1,'D:\USER\ETSI_SEM.xml'

Loads a spectrum emission mask setup from the specified file.

Mode: WLAN

Manual operation: See "File Name" on page 81

MMEMory:STORe:IQ:STATe 1, <FileName>

This command stores the I/Q data to the specified .iqw file.

Parameters:

Example:

MMEM:STOR:IQ:STAT 1, 'C:

\R_S\Instr\user\data.iqw'

Stores I/Q data to the specified file.

Mode: WLAN

Manual operation: See "Export" on page 68

MMEMory Subsystem (WLAN)