Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
179Operating Manual 1176.7649.02 ─ 04
INPut:SELect <Source>
This command selects the signal source for measurements.
Parameters:
<Source> RF | DIQ
RF
Radio Frequency ("RF INPUT" connector)
DIQ
Digital IQ (only available with R&S Digital I/Q Interface, option
R&S FSV-B17)
*RST: RF
Example: INP:SEL RF
Mode: A, IQ, NF, TDS, VSA, CDMA, EVDO, WCDMA, ADEMOD,
GSM, OFDM, OFDMA/WiBro, WLAN
Manual operation: See "Input" on page 91
5.12 INSTrument Subsystem (WLAN)
The INSTrument subsystem selects the operating mode of the unit either via text
parameters or fixed numbers.
INSTrument[:SELect]......................................................................................................179
INSTrument:NSELect..................................................................................................... 179
INSTrument[:SELect] <Mode>
Parameters:
<Mode> WLAN
Selects WLAN TX mode (R&S FSV-K91/91n/91ac/91p option)
INSTrument:NSELect <Mode>
Parameters:
<Mode> 16
Selects WLAN TX mode (R&S FSV-K91/91n/91ac/91p option)
5.13 MMEMory Subsystem (WLAN)
The MMEMory (mass memory) subsystem provides commands to store and load IQ
data.
INSTrument Subsystem (WLAN)