Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
176Operating Manual 1176.7649.02 ─ 04
5.9 FORMat Subsystem
FORMat[:DATA] <Format>
This command selects the data format for the data transmitted from the R&S FSV to
the controlling computer. It is used for the transmission of trace data. The data format
of trace data received by the instrument is automatically recognized, regardless of the
format which is programmed.
(See also TRACe[:DATA]? on page 209).
Parameters:
<Format> ASCii
ASCII data are transmitted in plain text, separated by commas.
REAL
REAL data are transmitted as 32-bit IEEE 754 floating-point
numbers in the "definite length block format".
UINT
In operating mode "WLAN" (R&S FSV-K91,91n option), bit
stream data is sent as unsigned integers in binary format.
*RST: ASCII
Example:
FORM REAL,32
FORM ASC
5.10 INITiate Subsystem
INITiate<n>:CONTinuous................................................................................................176
INITiate<n>[:IMMediate]..................................................................................................177
INITiate<n>:CONTinuous <State>
This command determines whether the trigger system is continuously initiated (contin-
uous) or performs single measurements (single).
The sweep is started immediately.
Suffix:
<n>
.
irrelevant
Parameters:
<State> ON | OFF
*RST: ON
Example:
INIT:CONT OFF
Switches the sequence to single sweep.
INIT:CONT ON
Switches the sequence to continuous sweep.
Mode: all
FORMat Subsystem