Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
174Operating Manual 1176.7649.02 ─ 04
FETCh:BURSt:PEAK?
This command returns the Peak power in dBm measured during the measurement
time.
Example:
FETC:BURS:PEAK?
The calculated peak power from the most recent measurement
is returned.
Usage: Query only
Mode: WLAN
FETCh:
BURSt:PREamble?
This command returns the measured power in the burst preamble.
Example:
FETC:BURS:PRE?
The burst preamble power is returned
Usage: Query only
Mode: WLAN
FETCh:BURSt:QUADoffset:AVERage?
FETCh:BURSt:QUADoffset:MAXimum?
FETCh:BURSt:QUADoffset:MINimum?
This command returns the accuracy in terms of the phase error of symbols within a
burst.
Example:
FETC:BURS:QUAD:MAX?
The maximum angle error recorded for a symbol during the
measurement.
Usage: Query only
Mode: WLAN
FETCh:BURSt:RMS[:AVERage]?
FETCh:BURSt:RMS:MAXimum?
FETCh:BURSt:RMS:MINimum?
This command returns the average, minimum or maximum RMS burst power in dBm
measured during the measurement.
Example:
FETC:BURS:RMS:MAX?
The maximum calculated RSM burst power from the most recent
measurement is returned.
Usage: Query only
Mode: WLAN
FETCh Subsystem (WLAN)