Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
164Operating Manual 1176.7649.02 ─ 04
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel[:RF]................................................ 167
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel:IQ................................................... 167
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel:OFFSet........................................... 168
DISPlay[:WINDow<n>][:SUBWindow<m>]:SIZE <Size>
This command configures the measurement display.
Suffix:
<n>
.
1 | 2
window;
Channel and adjacent-channel power measurements: Only "1" is
allowed as a suffix for the window.
Spectrum Emission Mask and Spurious Emissions measure-
ments:
selects the window that is displayed in full size (if no suffix is
defined, "1" is used):
1: diagram/result list
2: marker table
<m> 1 | 2
selects the item in the window to be displayed in full size:
1: diagram
2: result list
Parameters:
<Size> LARGe | SMALl
LARGe
Channel and adjacent-channel power measurements: diagram
in full screen.
Spectrum Emission Mask and Spurious Emissions measure-
ments: diagram or list in full screen, depending on the value of
the suffix.
SMALl
split screen (diagram and list and table)
*RST: SMALl
Example:
DISP:SIZE LARG
Displays the measurement diagram in full screen size.
DISP:WIND1:SUBW2:SIZE LARG
Displays the result list in full screen size.
DISP:WIND2:SIZE LARG
Displays the marker table in full screen size.
Mode: all
Manual operation: See "Screen Size Full/Split" on page 111
DISPlay[:WINDow<n>]:SSELect
This command selects whether screen A or screen B is active. SSELect means Screen
SELect.
DISPlay Subsystem (WLAN)