Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
163Operating Manual 1176.7649.02 ─ 04
Manual operation: See "User Defined Spatial Mapping" on page 109
CONFigure:WLAN:SMAPping:TX<1...4>:TIMeshift <TimeShift>
This remote control command specifies the timeshift for a specific antenna.
Suffix:
TX<1...4>
.
Defines the TX antenna
Parameters:
<TimeShift> Time shift (in s) for specification of user defined CSD (cyclic
delay diversity) for the Spatial Mapping.
Range: -32 ns to 32 ns
Example:
CONF:WLAN:SMAP:TX1:TIM 0
Manual operation: See "User Defined Spatial Mapping" on page 109
CONFigure:WLAN:STBC:AUTO:TYPE <BurstType>
This remote control command specifies which bursts are analyzed according to STBC
streams.
Parameters:
<BurstType> FBURst
First burst is analyzed and subsequent bursts are analyzed only
if they match.
ALL
All bursts are analyzed.
M0 | M1 | M2
Measure only if STBC field = 0 | 1 | 2
D0 | D1 | D2
Demod all as STBC field = 0 | 1 | 2
Example:
CONF:WLAN:STBC:AUTO:TYPE?
Manual operation: See "STBC field" on page 106
5.7 DISPlay Subsystem (WLAN)
The DISPLay subsystem controls the selection and presentation of textual and graphic
information as well as of measurement data on the display. In contrast to the basic
device, the WLAN TX Measurements option supports the split screen modus.
DISPlay[:WINDow<n>][:SUBWindow<m>]:SIZE................................................................164
DISPlay[:WINDow<n>]:SSELect......................................................................................164
DISPlay[:WINDow<n>]:TABLe.........................................................................................165
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:AUTO......................................................... 165
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:PDIVision.................................................... 166
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel?......................................................166
DISPlay Subsystem (WLAN)