Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
161Operating Manual 1176.7649.02 ─ 04
CONFigure:WLAN:PVERror:MRANge <Range>
This remote control command specifies whether the Peak Error Vector results are cal-
culated over the complete burst or just over the PSDU.
This command is supported for 802.11b and 802.11g only.
Parameters:
<Range> ALL
Peak Error Vector results are calculated over the complete burst
PSDU
Peak Error Vector results are calculated over the PSDU only
*RST: ALL
Example:
CONF:WLAN:PVER:MRANge PSDU
Peak Error Vector results are calculated over the PSDU only
Mode: WLAN
Manual operation: See "Meas Range (IEEE 802.11b, g)" on page 93
CONFigure:WLAN:RSYNc:JOINed <State>
This command configures how burst synchronization and tracking is performed for mul-
tiple antennas.
Parameters:
<State> ON | OFF
ON
RX antennas are synchronized and tracked together.
OFF
RX antennas are synchronized and tracked separately.
*RST: OFF
Mode: WLAN (IEEE 802.11ac/n (MIMO))
Manual operation: See "Joined RX Sync and Tracking" on page 95
CONFigure:WLAN:SMAPping:MODE <Mode>
This remote control command specifies the special mapping mode.
Parameters:
<Mode> DIRect
direct
SEXPansion
expansion
USER
user defined
Example:
CONF:WLAN:SMAP:MODE DIR
Manual operation: See "Spatial Mapping Mode" on page 109
CONFigure Subsystem (WLAN)