Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
160Operating Manual 1176.7649.02 ─ 04
Mode: WLAN (IEEE 802.11ac/n (MIMO))
Manual operation: See "Signal Capture" on page 94
CONFigure:WLAN:OSP:ADDRess <Address>
Specifies the TCP/IP address of the switch unit to be used for automated sequential
MIMO measurements. The supported unit is Rohde & Schwarz OSP 1505.3009.03
with module option 1505.5101.02
Parameters:
<ID> TCP/IP address in dotted IPV4 format
Example:
CONF:WLAN:MIM:OSP:ADDR '192.168.114.157'
Mode: WLAN (IEEE 802.11ac/n (MIMO))
Manual operation: See "OSP IP Address" on page 96
CONFigure:WLAN:OSP:MODule <ID>
Specifies the module of the switch unit to be used for automated sequential MIMO
measurements. The supported unit is Rohde & Schwarz OSP 1505.3009.03 with mod-
ule option 1505.5101.02
Parameters:
<ID> Module ID
*RST: A11
Example:
CONF:WLAN:MIM:OSP:MOD A11
Mode: WLAN (IEEE 802.11ac/n (MIMO))
Manual operation: See "OSP Switch Module" on page 96
CONFigure:WLAN:PAYload:LENgth:SRC <Source>
Determines if the payload length should be taken from the signal field decoding result
or from the signal (IEEE 802.11ac/n (MIMO)).
Parameters:
<Source> ESTimate
Signal
HTSignal
signal field decoding result
Example:
CONF:WLAN:PAY:LEN:SRC EST
use signal
Manual operation: See "Source of Payload Length" on page 108
CONFigure Subsystem (WLAN)