Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
159Operating Manual 1176.7649.02 ─ 04
Mode: WLAN (IEEE 802.11n)
Manual operation: See "Guard Interval (IEEE 802.11n, SISO)" on page 100
CONFigure:WLAN:MIMo:CAPTure <SignalPath>
Specifies the signal path to be captured in MIMO sequential manual measurements.
Subsequently, use the INITiate<n>[:IMMediate] command to start capturing
data.
Parameters:
<SignalPath> RX1 | RX2 | RX3 | RX4
For details see "Signal Capture" on page 94
*RST: RX1
Example:
CONF:WLAN:DUTC TX4
Specify the number of antennas used for MIMO measurement
as 2.
CONF:WLAN:MIMO:CAPT:TYPE MAN
Specify sequential MIMO measurement using manual operation.
Pause the script and connect TX1 of the DUT to the analyzer.
Continue the script
CONF:WLAN:MIM:CAPT RX1
Select RX1 for the next capture.
INIT:IMM
Capture the selected channel
Pause the script and connect TX2 of the DUT to the analyzer.
Continue the script
CONF:WLAN:MIM:CAPT RX2
Select RX2 for the next capture.
INIT:IMM
Capture the selected channel
CALC:BURS:IMM
Analyze the captured data
Mode:
WLAN (IEEE 802.11ac/n (MIMO))
CONFigure:WLAN:MIMo[:CAPTure]:TYPe <Method>
Specifies the method used to analyze MIMO signals.
Parameters:
<Method> SIMultaneous
Simultaneous normal MIMO operation
OSP
Sequential using open switch platform
MANual
Sequential using manual operation
*RST: SIM
Example:
CONF:WLAN:MIM:TYP SIM
CONFigure Subsystem (WLAN)