Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
157Operating Manual 1176.7649.02 ─ 04
Parameters:
<BurstType> The first burst is analyzed and subsequent bursts are analyzed
only if they match
FBURst
The first burst is analyzed and subsequent bursts are analyzed
only if they match
ALL
All bursts are analyzed
M0 | M1 | M2 | M3
Measure only if Ness 0 | 1 | 2 | 3
D0 | D1 | D2| D3
Demod all as Ness 0 | 1 | 2 | 3
Example:
CONF:WLAN:EXT:AUTO:TYPE?
Manual operation: See "Extension spatial streams (sounding) (IEEE 802.11ac or n
(MIMO) only)" on page 108
CONFigure:WLAN:GTIMe:AUTO <State>
This remote control command specifies wether the guard time of the IEEE 802.11n
(SISO) input signal is automatically detected or specified manually.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CCONF:WLAN:GTIM:AUTO ON
Sets automatic detection of the guard time of the input signal
Mode: WLAN
Manual operation: See "Auto Guard Interval (IEEE 802.11n, SISO)" on page 100
CONFigure:WLAN:GTIMe:AUTO:TYPE <TYPE>
This remote control command specifies how bursts are analyzed according to guard
length.
Note: In previous R&S FSV-K91 versions, this command configured both the guard
interval type and the channel bandwidth. Now this command only configures the guard
type. The channel bandwidth of the PPDU to be measured must be configured sepa-
rately using the [SENSe:]BANDwidth:CHANnel:AUTO:TYPE command.
CONFigure Subsystem (WLAN)