Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
156Operating Manual 1176.7649.02 ─ 04
Suffix:
<RecPath>
.
1..4
Defines the receiver path.
Parameters:
<Antenna> ANTENNA1 | ANTENNA2
Antenna assignment of the receiver path
Example:
CONF:WLAN:ANTM:ANT2 ANTENNA1
Manual operation: See "Assignment" on page 94
CONFigure:WLAN:ANTMatrix:STATe<RecPath> State
This remote control command specifies the state of the receive path. Note, it is not
possible to set the state of ANTMatrix1 (Master).
Suffix:
<RecPath>
.
1..4
Defines the receiver path.
Parameters:
<State> ON | OFF
State of the receive path
Example:
CONF:WLAN:ANTM:STAT2 ON
Manual operation: See "State" on page 94
CONFigure:WLAN:DUTConfig <NoOfAnt>
This remote control command specifies the number of antennas used for MIMO mea-
surement.
Parameters:
<NoOfAnt> TX1 | TX2 | TX3 | TX4
TX1: one antenna,
TX2: two antennas etc.
Example:
CONF:WLAN:DUTC TX1
Manual operation: See "DUT MIMO configuration" on page 93
CONFigure:WLAN:EXTension:AUTO:TYPE <BurstType>
This remote control command specifies which bursts are analyzed according to exten-
sion spatial streams.
CONFigure Subsystem (WLAN)