Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
155Operating Manual 1176.7649.02 ─ 04
Parameters:
<Standard> 0 | 1 | 2 | 3 | 4 | 6 | 7
0
IEEE 802.11a
1
IEEE 802.11b
2
IEEE 802.11j (10 MHz)
3
IEEE 802.11j (20 MHz)
4
IEEE 802.11g
5
Turbo
6
IEEE 802.11n
7
IEEE 802.11n (MIMO)
8
IEEE 802.11ac
9
IEEE 802.11p
*RST:
0
Example:
CONF:STAN 0
Selects the IEEE 802.11a standard for the measurement.
Mode: WLAN
Manual operation: See "Standard " on page 88
CONFigure:WLAN:ANTMatrix:ADDRess<RecPath> <Address>
This remote control command specifies the TCP/IP address for each receiver path in
IPV4 format. Note, it is not possible to set the IP address of ANTMatrix1 (Master)
Suffix:
<RecPath>
.
1..4
Defines the receiver path.
Parameters:
<Address> TCP/IP address in IPV4 format
Example:
CONF:WLAN:ANTM:ADDR2 ‘192.168.114.157’
Manual operation: See "Analyzer IP Address" on page 94
CONFigure:WLAN:ANTMatrix:ANTenna<RecPath> <Antenna>
This remote control command specifies the antenna assignment of the receive path.
CONFigure Subsystem (WLAN)