Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
152Operating Manual 1176.7649.02 ─ 04
CONFigure:BURSt:SPECtrum:MASK[:IMMediate]
This remote control command configures the measurement type to be Spectrum Mask.
After this command has been executed, the specified measurement will only be started
when the user issues the INITiate<n>[:IMMediate] command
Example:
CONF:BURS:SPEC:MASK
Configures the Spectrum Mask measurement type.
Mode: WLAN
Manual operation: See "Spectrum Mask (IEEE 802.11ac, b, g (Single Carrier)) /
Spectrum IEEE/ETSI (IEEE 802.11a, g, j, n (OFDM), p)"
on page 78
CONFigure:
BURSt:SPECtrum:MASK:SELect <Mode>
This remote control configures the interpretation of the Spectrum Mask measurement
results. This command is only available for IEEE 802.11a & p.
Parameters:
<Mode> IEEE | ETSI
Example:
CONF:BURS:SPEC:MASK:SEL ETSI
Interprets the measurement results using the ETSI standard.
Mode: WLAN
Manual operation: See "Spectrum Mask (IEEE 802.11ac, b, g (Single Carrier)) /
Spectrum IEEE/ETSI (IEEE 802.11a, g, j, n (OFDM), p)"
on page 78
CONFigure:BURSt:STATistics:BSTReam[:IMMediate]
This remote control command configures the measurement type to be Bitstream. After
this command has been executed, the specified measurement will only be started
when the user issues the INITiate<n>[:IMMediate] command.
Example:
CONF:BURS:STAT:BSTR
Configures the Bitstream measurement type.
Mode: WLAN
Manual operation: See "Bitstream" on page 83
CONFigure:BURSt:STATistics:CCDF[:IMMediate]
This remote control command configures the measurement type to be CCDF (condi-
tional cumulative distribution functions.). After this command has been executed, the
specified measurement will only be started when the user issues the INITiate<n>[:
IMMediate] command.
Example:
CONF:BURS:STAT:CCDF
Configures the CCDF measurement type.
CONFigure Subsystem (WLAN)