Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
151Operating Manual 1176.7649.02 ─ 04
CONFigure:BURSt:SPECtrum:FLATness[:IMMediate]
This remote control command configures the measurement type to be Spectrum Flat-
ness. After this command has been executed, the specified measurement will only be
started when the user issues the INITiate<n>[:IMMediate] command.
Example:
CONF:BURS:SPEC:FLAT
Configures the Spectrum Flatness measurement type.
Mode: WLAN
Manual operation: See "Spectrum Flatness (IEEE 802.11a, ac, g, j, n (OFDM), p /
Group Delay (IEEE 802.11 n (MIMO))" on page 76
CONFigure:
BURSt:SPECtrum:FLATness:CSELect <CSelect>
This remote control command configures the Spectrum Flatness channel selection.
This command is only valid for IEEE 802.11ac, n and IEEE 802.11n (MIMO).
Parameters:
<CSelect> EFFective
Effective channel
PHYSical
Physical channel
Example:
CONF:BURS:SPEC:FLAT:SEL PHY
Flatness measurement channel is configured as Physical.
Manual operation: See "Chan Sel" on page 82
CONFigure:BURSt:SPECtrum:FLATness:SELect <MeasType>
This remote control command configures the Spectrum Flatness measurement type.
This command is only valid for IEEE 802.11ac, n and IEEE 802.11n (MIMO).
Parameters:
<MeasType> FLATness
Spectrum Flatness results
GRDelay
Spectrum Flatness Group Delay results
Example:
CONF:BURS:SPEC:FLAT:SEL GRD
Flatness measurement type is configured as Spectrum Flatness
Group Delay
Manual operation: See "Spectrum Flatness (IEEE 802.11a, ac, g, j, n (OFDM), p /
Group Delay (IEEE 802.11 n (MIMO))" on page 76
CONFigure Subsystem (WLAN)