Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
149Operating Manual 1176.7649.02 ─ 04
Mode: WLAN
Manual operation: See "PVT" on page 64
CONFigure:BURSt:PVT:AVERage <Value>
This remote control command configures the measurement type to set the burst power
averaging length to the desired value. This command is only valid when the selected
standard is IEEE 802.11b.
Parameters:
<Value>
Example:
CONF:BURS:PVT:AVER 31
Configures the burst power average length of 31.
Mode: WLAN
Manual operation: See "Average Length (IEEE 802.11b, g – Single Carrier)"
on page 67
CONFigure:BURSt:PVT:RPOWer <Mode>
This remote control command configures the use of either mean or maximum burst
power as a reference power for the 802.11b PVT measurement.
Parameters:
<Mode> MEAN | MAXimum
Example:
CONF:BURS:PVT:RPOW MEAN
Configures to use mean burst power as a reference power.
Mode: WLAN
Manual operation: See "Ref Pow Max/Mean (IEEE 802.11b, g – Single Carrier)"
on page 67
CONFigure:BURSt:PVT:SELect <Mode>
This remote control configures how to interpret the Power vs Time measurement
results.
CONFigure Subsystem (WLAN)