Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
147Operating Manual 1176.7649.02 ─ 04
Parameters:
<Mode> -26 to 26 | ALL | PILOTS
*RST: ALL
Example:
CONF:BURS:CONS:CARR:SEL -26
Carrier -26 is selected.
CONF:BURS:CONS:CARR:SEL 10
Carrier 10 is selected.
CONF:BURS:CONS:CARR:SEL ALL
All carriers are selected.
CONF:BURS:CONS:CARR:SEL PIL
Pilots only.
Mode: WLAN
Manual operation: See "Carrier Selection (IEEE 802.11a, ac, g, j, n (OFDM), p)"
on page 75
CONFigure:
BURSt:CONStellation:CCARrier[:IMMediate]
This remote control command configures the measurement type to be Constellation vs
Carrier. After this command has been executed, the specified measurement will only
be started when the user issues the INITiate<n>[:IMMediate] command.
Example:
CONF:BURS:CONS:CCAR
Configures the Constellation versus Carrier measurement type.
Mode: WLAN
Manual operation: See "Constell vs Symbol/Carrier" on page 73
CONFigure:BURSt:CONStellation:CSYMbol[:IMMediate]
This remote control command configures the measurement type to be Constellation vs
Symbol. After this command has been executed, the specified measurement will only
be started when the user issues the INITiate<n>[:IMMediate] command
Example:
CONF:BURS:CONS:CSYM
Configures the Constellation versus Symbol measurement type.
Mode: WLAN
Manual operation: See "Constell vs Symbol/Carrier" on page 73
CONFigure:BURSt:EVM:ECARrier[:IMMediate]
This remote control command configures the measurement type to be EVM vs Carrier.
After this command has been executed, the specified measurement will only be started
when the user issues the INITiate<n>[:IMMediate] command.
Example:
CONF:BURS:EVM:ECAR
Configures the EVM vs Carrier measurement type.
CONFigure Subsystem (WLAN)