Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
145Operating Manual 1176.7649.02 ─ 04
Suffix:
<n>
.
1...4
irrelevant
Example:
CALC:MARK:FUNC:POW:RES:MAXH?
Usage: Query only
Mode: WLAN
Manual operation: See "Spectrum ACPR (IEEE 802.11a, ac, g (OFDM Turbo
Mode), n, p)/ Spectrum ACP (IEEE 802.11b)/ ACP Rel/Abs
(IEEE 802.11j)" on page 80
CALCulate<n>:MARKer<1>:FUNCtion:ZOOM <Factor>
This command sets the magnification factor for the zoom. It is only available for the fol-
lowing result displays:
●
Constellation vs Carrier
●
Constellation vs Symbol
●
PVT
●
Magnitude Capture Buffer
Suffix:
<n>
.
1...4
irrelevant
Parameters:
<Factor>
Example:
INIT:CONT OFF
Switches to single sweep mode
CALC:MARK:FUNC:ZOOM 3;*WAI
Activates zooming and waits for its end.
Mode: WLAN
Manual operation: See "Unzoom" on page 112
See "Marker Zoom" on page 112
5.6 CONFigure Subsystem (WLAN)
The CONFigure subsystem contains commands for configuring complex measurement
tasks. The CONFigure subsystem is closely linked to the functions of the FETCH sub-
system, where the measurement results are queried.
CONFigure:BURSt:CONStellation:CARRier:SELect...........................................................146
CONFigure:BURSt:CONStellation:CCARrier[:IMMediate]................................................... 147
CONFigure:BURSt:CONStellation:CSYMbol[:IMMediate]................................................... 147
CONFigure:BURSt:EVM:ECARrier[:IMMediate].................................................................147
CONFigure:BURSt:EVM:ESYMbol[:IMMediate].................................................................148
CONFigure Subsystem (WLAN)