Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
142Operating Manual 1176.7649.02 ─ 04
Example:
CALC2:MARK:SYMB 2
Positions marker 1 in screen B to symbol 2.
CALC2:MARK:SYMB?
Outputs the symbol value of marker 1 in screen B.
Mode: WLAN, OFDM, OFDMA/WiBro
Manual operation: See "Marker 1" on page 112
CALCulate<n>:MARKer<1>:TRACe <TraceNo>
This command assigns the selected marker to the indicated measurement curve in the
selected measurement window.
This command is only available for the following result displays:
●
Constellation versus Carrier
●
EVM vs Symbol
●
Frequency Error vs Preamble
●
Phase Error vs Preamble
●
PVT Full Burst
●
PVT Rising/Falling
●
Spectrum Flatness
●
Spectrum Mask, if Max Hold trace is displayed
●
Spectrum ACP/ACPR, if Max Hold trace is displayed
Suffix:
<n>
.
1...4
window
Parameters:
<TraceNo> Trace number to be assigned to the marker.
*RST: 1
Example:
"CALC2:MARK:TRAC 2
Assigns marker 1 in screen B to trace 2.
Mode: WLAN
Manual operation: See "MKR -> Trace" on page 113
CALCulate<n>:MARKer<1>:X <Position>
This command positions the selected marker to the indicated inphase (Constellation vs
Symbol), frequency (Spectrum FFT, Spectrum Mask, Spectrum APCR), time (Magni-
tude Capture Buffer, Auto level, PVT Full Burst, PVT Rising / Falling), power (CCDF),
sub-carrier (Constellation vs Carrier, EVM vs Carrier, Spectrum Flatness) or symbol
(EVM vs Symbol) in the selected measurement window.
This command is query only for the following result displays:
●
Constellation vs Symbol
CALCulate:MARKer Subsystem (WLAN)