Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
141Operating Manual 1176.7649.02 ─ 04
Mode: WLAN, OFDM, OFDMA/WiBro
Manual operation: See "Marker 1" on page 112
CALCulate<n>:MARKer<1>:MAXimum
This command sets the selected marker to the maximum peak value in the current
trace. This command is only available for the Spectrum Flatness result display.
Suffix:
<n>
.
1...4
window
Example:
CALC2:MARK:MAX
Set marker 1 in screen B to maximum value in trace.
Mode: WLAN, OFDM, OFDMA/WiBro
Manual operation: See "Peak (Spectrum Flatness result display)" on page 112
CALCulate<n>:
MARKer<1>:MINimum
This command sets the selected marker to the minimum peak value in the current
trace. This command is only available for the Spectrum Flatnes result display.
Suffix:
<n>
.
1...4
window
Example:
CALC2:MARK:MIN
Set marker 1 in screen B to minimum value in trace.
Mode: WLAN, OFDM, OFDMA/WiBro
Manual operation: See "Min (Spectrum Flatness result display)" on page 112
CALCulate<n>:MARKer<1>:SYMBol <Symbol>
This command positions the selected marker to the indicated symbol.
This command is query only for the following result displays:
●
Constellation vs Symbol
●
Constellation vs Carrier
Suffix:
<n>
.
1...4
window
Parameters:
<Symbol> 1 to <number of symbols in selected burst>
CALCulate:MARKer Subsystem (WLAN)