Service manual

WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
14Operating Manual 1176.7649.02 ─ 04
3. Activate "Auto Demodulation" (see "Auto Demodulation (IEEE 802.11n, SISO)"
on page 99) to use the content of the signal inherent field to detect the modula-
tion type automatically.
3.2.2 Performing the Main Measurement
●
Select single sweep measurements by pressing the RUN SINGLE hardkey.
●
Select continuous measurements by pressing the RUN CONT hardkey.
During the measurement, the status message "Running" is displayed.
Leveling is done automatically.
Measurement results are updated once the measurement has completed. The
results are displayed in graphical form. The display can be toggled to a tabular list
of measurement points by pressing the "Display" softkey (in the "WLAN" menu or
"Trace" menu).
3.2.3 Setting up a MIMO measurement
For this example a 2 Tx MIMO DUT according to IEEE 802.11n is used.
1. The MIMO DUT is connected to the analyzers according to the following setup:
Basic Measurement Examples