Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
139Operating Manual 1176.7649.02 ─ 04
The following subsystem is included:
chapter 5.5.2, "CALCulate:MARKer:FUNCtion Subsystem (WLAN, R&S FSV-
K91/91n)", on page 144
5.5.1 Description of the CALCulate:MARKer Subsystem (WLAN, R&S FSV K91/91n).......139
5.5.2
CALCulate:MARKer:FUNCtion Subsystem (WLAN, R&S FSV-K91/91n)...................144
5.5.1 Description of the CALCulate:MARKer Subsystem (WLAN, R&S
FSV K91/91n)
CALCulate<n>:MARKer<m>[:STATe]...............................................................................139
CALCulate<n>:MARKer<m>:AOFF..................................................................................139
CALCulate<n>:MARKer<1>:BSYMbol..............................................................................140
CALCulate<n>:MARKer<1>:CARRier...............................................................................140
CALCulate<n>:MARKer<1>:MAXimum............................................................................ 141
CALCulate<n>:MARKer<1>:MINimum..............................................................................141
CALCulate<n>:MARKer<1>:SYMBol................................................................................141
CALCulate<n>:MARKer<1>:TRACe.................................................................................142
CALCulate<n>:MARKer<1>:X......................................................................................... 142
CALCulate<n>:MARKer<1>:Y......................................................................................... 143
CALCulate<n>:MARKer<m>[:STATe] <State>
This command turns markers on and off.
If the corresponding marker number is currently active as a deltamarker, it is turned
into a normal marker.
Suffix:
<n>
.
Selects the measurement window.
<m> depends on mode
Selects the marker.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:MARK3 ON
Switches on marker 3 or switches to marker mode.
Manual operation: See "Marker 1" on page 112
CALCulate<n>:MARKer<m>:AOFF
This command all markers off, including delta markers and marker measurement func-
tions.
Suffix:
<n>
.
Selects the measurement window.
CALCulate:MARKer Subsystem (WLAN)