Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
124Operating Manual 1176.7649.02 ─ 04
Example:
CALC:LIM:ACP:ALT2 30DB, 30DB
Sets the relative limit value for the power in the lower and upper
second alternate adjacent channel to 30 dB below the channel
power.
CALCulate<n>:LIMit<1>:BURSt:ALL
This command sets or returns all the limit values.
Suffix:
<n>
.
1...4
irrelevant
Return values:
<Results> The results are input or output as a list of values separated by ','
in the following (ASCII) format:
<average frequency error>, <max frequency error>,
<average symbol error>, <max symbol error>,
<average IQ offset>, <maximum IQ offset>,
<average EVM all bursts>, <max EVM all bursts>,
<average EVM data carriers >, <max EVM data carriers >
<average EVM pilots >, <max EVM pilots >
The units for the EVM results are specified with the UNIT:EVM
command.
Example:
CALC:LIM:BURS:ALL?
All limit values are returned
Mode: WLAN
CALCulate<n>:LIMit<1>:BURSt:ALL:RESUlt?
This command returns all the limit results.
Suffix:
<n>
.
1...4
irrelevant
Return values:
<Results>
For details on formats refer to FETCh:BURSt:ALL?
on page 170.
Example:
CALC:LIM:BURS:ALL:RES?
All limit values are returned
Usage: Query only
Mode: WLAN
CALCulate<n>:LIMit<1>:BURSt:EVM[:AVERage] <Value>
This command sets the average error vector magnitude limit for the IEEE 802.11b
standard.
CALCulate:LIMit Subsystem (WLAN)