Service manual

Remote Commands for WLAN TX Measurements

R&S

FSV-K91/91n/91ac/91p

120Operating Manual 1176.7649.02 ─ 04

The numeric values associated to MAXimum/MINimum/DEFault can be queried by

adding the corresponding keywords to the command. They must be entered following

the quotation mark.

Example:

SENSe:FREQuency:CENTer? MAXimum

Returns the maximum possible numeric value of the center frequency as result.

This keyword is provided for commands the parameters of which consist of a binary

data block.

5.2 ABORt Subsystem

ABORt

This command aborts a current measurement and resets the trigger system.

Example:

ABOR;INIT:IMM

Mode: all

5.3 CALCulate:BURSt Subsystem (WLAN)

The CALCulate:BURSt subsystem checks the I/Q measurement results.

CALCulate<n>:BURSt[:IMMediate].................................................................................. 120

CALCulate<n>:BURSt[:IMMediate]

This command forces the I/Q measurement results to be recalculated according to the

current settings.

Suffix:

<n>

1...4

irrelevant

Example:

CALC1:BURS

Starts the recalculation of the IQ measurement results.

Usage: Event

Mode: WLAN

Manual operation: See "Analyze" on page 97

ABORt Subsystem