Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
118Operating Manual 1176.7649.02 ─ 04
Abbreviation Description
A spectrum analysis
A-F spectrum analysis – span > 0 only (frequency mode)
A-T spectrum analysis – zero span only (time mode)
ADEMOD
analog demodulation (option R&S FSV-K7)
BT
Bluetooth (option R&S FSV-K8)
CDMA
CDMA 2000 base station measurements (option R&S FSV-K82)
EVDO
1xEV-DO base station analysis (option R&S FSV-K84)
GSM
GSM/Edge measurements (option R&S FSV-K10)
IQ IQ Analyzer mode
OFDM
WiMAX IEEE 802.16 OFDM measurements (option R&S FSV-K93)
OFDMA/WiBro
WiMAX IEEE 802.16e OFDMA/WiBro measurements (option R&S FSV-K93)
NF
Noise Figure measurements (R&S FSV-K30)
PHN
Phase Noise measurements (R&S FSV-K40)
PSM
Power Sensor measurements (option R&S FSV-K9)
SFM
Stereo FM measurements (optionR&S FSV-K7S)
SPECM
Spectogram mode (option R&S FSV-K14)
TDS
TD-SCDMA base station / UE measurements (option R&S FSV-K76/K77)
VSA
Vector Signal Analysis (option R&S FSV-K70)
WCDMA
3GPP Base Station measurements (option R&S FSV-K72), 3GPP UE measure-
ments (option R&S FSV-K73)
WLAN
WLAN TX measurements (option R&S FSV-K91)
The spectrum analysis mode is implemented in the basic unit. For the other modes, the
corresponding options are required.
Upper/Lower Case Notation
Upper/lower case letters are used to mark the long or short form of the key words of a
command in the description. The instrument itself does not distinguish between upper
and lower case letters.
Special Characters
| A selection of key words with an identical effect exists for several commands. These keywords
are indicated in the same line; they are separated by a vertical stroke. Only one of these key-
words needs to be included in the header of the command. The effect of the command is inde-
pendent of which of the keywords is used.
Example:
Notation