Service manual

Instrument Functions WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
112Operating Manual 1176.7649.02 ─ 04
Marker 1
Opens a dialog box to adjust the marker. The contents of the dialog box depend on the
type of graph the marker is adjusted to. After every change, the marker position in the
trace and the marker information are updated.
Remote command:
CALCulate<n>:MARKer<m>[:STATe] on page 139
CALCulate<n>:MARKer<1>:X on page 142
CALCulate<n>:MARKer<1>:Y on page 143
CALCulate<n>:MARKer<1>:SYMBol on page 141
CALCulate<n>:MARKer<1>:CARRier on page 140
Unzoom
Cancels the marker zoom.
Remote command:
CALCulate<n>:MARKer<1>:FUNCtion:ZOOM on page 145
Marker Zoom
Opens an edit dialog box to select the magnification factor for the zoom. The zoom
facility is provided for the following result displays: Magnitude Capture Buffer, PVT,
Constellation vs Symbol, Constellation vs Carrier. The maximum magnification
depends on the type of result display.
Remote command:
CALCulate<n>:MARKer<1>:FUNCtion:ZOOM on page 145
Marker Off
Switches off all makers in the active result display.
Remote command:
CALCulate<n>:MARKer<m>:AOFF on page 139
4.7 Softkeys of the Marker To Menu – MKR-> key
The following table shows all softkeys available in the "Marker To" menu in "WLAN"
mode (MKR-> key). It is possible that your instrument configuration does not provide all
softkeys. If a softkey is only available with a special option, model or (measurement)
mode, this information is delivered in the corresponding softkey description.
Peak (Spectrum Flatness result display)
Sets the marker to the peak value of the assigned trace.
Remote command:
CALCulate<n>:MARKer<1>:MAXimum on page 141
Min (Spectrum Flatness result display)
Sets the marker to the minimum value of the assigned trace.
Remote command:
CALCulate<n>:MARKer<1>:MINimum on page 141
Softkeys of the Marker To Menu – MKR-> key