Service manual

Instrument Functions WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
110Operating Manual 1176.7649.02 ─ 04















































4
1
44
11
4
1
.
.
4.,..1.,
..
..
4.,..1.,
.
.
StreamSTS
StreamSTS
STSTxSTSTx
STSTxSTSTx
StreamTx
StreamTx
Remote command:
CONFigure:WLAN:SMAPping:TX<1...4> on page 162
CONFigure:WLAN:SMAPping:TX<1...4>:STReam<1...4> on page 162
CONFigure:WLAN:SMAPping:TX<1...4>:TIMeshift on page 163
4.4 Softkeys of the Sweep Menu – SWEEP key
The following table shows all softkeys available in the "Sweep" menu in "WLAN" mode
(SWEEP key). It is possible that your instrument configuration does not provide all soft-
keys. If a softkey is only available with a special option, model or (measurement)
mode, this information is delivered in the corresponding softkey description.
Run Single/Cont..........................................................................................................110
Auto Level................................................................................................................... 110
Refresh........................................................................................................................110
Run Single/Cont
Selects the sweep mode.
"Single"
single sweep mode
"Cont"
continuous sweep mode
Remote command:
INITiate<n>:CONTinuous on page 176
Auto Level
Starts an automatic level detection measurement. If this softkey is pressed while a
measurement is running, the current measurement is aborted and the automatic level
detection measurement is started. If the aborted measurement was a continuous mea-
surement it is resumed after the automatic level detection is completed.
Remote command:
CONFigure:POWer:AUTO on page 153
Refresh
Updates the current measurement results with respect to the current gate settings.
This softkey is only available if the measurement results are effected by the gate set-
tings (Spectrum FFT, PVT and CCDF) and if the gate settings are modified after a
measurement result has been obtained.
Softkeys of the Sweep Menu – SWEEP key