User`s manual

6 Installing and Using the Axel-VNCviewer
2.2 - SETTING UP THE MOUSE
The VNC Platine Terminal controls either PS/2 mouse or a serial 2-button
mouse.
2.2.1 - PS/2 Mouse
The PS/2 mouse is automatically enabled when a VNC session is set.
In event of problem, enter the AX3000 Set-Up (
<Ctrl><Alt><Esc>
) and select
the
[Configuration]
→
[Terminal]
→
[General]
menu. Within the displayed dialog
box, set the "Mouse" parameter to "PS2".
2.2.2 - Serial 2-button Mouse
Attach this mouse to the AUX2 port (if needed, use RJ45-9pts adaptor
supplied).
Note
: for electrical reasons, only a native serial mouse or a combo-mouse
(supporting both serial and PS/2 protocol) can be connected. For example, a
exclusive PS/2 mouse (equipped with a "9pts-PS/2" adaptor) won’t work.
To set-up the serial mouse, perform the following:
- enter the AX3000 Set-Up (
<Ctrl><Alt><Esc>
),
- select
[Configuration]
→
[Terminal]
→
[ General]
,
- within this dialog box, set "Mouse" to "AUX2",
- select
[Configuration]
→
[Aux. Ports]
→
[AUX2 (RJ45)]
,
- within this dialog box, set "Operating Mode" to "Mouse",
- exit the set-up,
- power-cycle the AX3000.