User Guide

92
A
A
X
X
4
4
G
G
E
E
T
T
u
u
b
b
e
e
/
/
A
A
X
X
4
4
P
P
E
E
T
T
u
u
b
b
e
e
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
***********************************************
WARNING: If you wish to use your current bootable drive with the Windows NT4 operating system on the SATA150, perform the steps
below while the boot drive is still attached to your existing onboard IDE controller. Do not attach any drives to your SATA150
until the steps below are complete.
1. Choose "Settings" from the "Start" menu.
2. Choose "Control Panel" from the "Settings" menu.
3. Double-click on the "SCSI Adapters" icon, which generates the "SCSI Adapters" dialog box.
4. Choose "Drivers," and then press "Add."
5. In the "Install Drivers" dialog box, press "Have Disk…"
6. When the "Install From Disk" appears, Insert the driver diskette into drive A:, then choose "OK."
7. When the "Install Driver" dialog box appears, select "WinNT Promise SATA TX2plus (tm) IDE Controller" and then press "OK."
8. When the "Select SCSI Adapter Option" dialog box appears, press "Install."
9. After a successful installation, the "SCSI Adapter Setup" box will show that the "WinNT Promise SATA TX2plus (tm) IDE Controller"
driver has been installed.
10. Power off your system, and then attach your hard drive(s) to the SATA150 controller.
*************************************************
Installing Drivers During Windows Me Installation
*************************************************
The following details the installation of the Serial ATA drivers while installing Windows Me (with the Serial ATA controller is enabled already).