User Guide

Hardware Installation
2-19
Some housings have a five-pin connector
for the keylock and power LED.
Speaker Keylock & Power LED
Break Switch Green Mode LED
( Turbo Switch ) ( Turbo LED )
Reset
Other housings may have a 12-pin
connector. If your housing has this type
of connector, plug it onto CN16 as
shown in the following figure. Make
sure that the red wire of the connector
connects to pin 11.
( Turbo Switch )
Break Switch
Ground
VCC
Ground
Ground
Keylock
Reset
Res-VCC
Speaker
2.9.8 Keyboard
The onboard keyboard connector is a
five-pin AT-compatible connector
marked CN2. Refer to the figure on how
to connect an AT keyboard.
The PS/2 keyboard connector is optional.