User Guide

Hardware Installation
2-18
Secondary IDE Connector
The secondary IDE connector is marked
CN11 on the board. This connector also
supports two IDE devices. To install an
IDE CD-ROM drive into your system,
insert master port of the secondary IDE
cable into the CD-ROM drive connector.
If you have more than two hard disks,
connect your third hard disk into the
master port. Connect your CD-ROM
drive into the slave port.
2.9.7 Front-panel Switches and LEDs
HDD LED
The HDD LED connector is marked
CN12 on the board. Plug the HDD LED
socket onto this four-pin connector. See
the figure.
Multifunction Connector
The multifunction connector is a 20-pin
connector marked CN16 on the board.
Attach the green mode LED, keylock,
reset switch, turbo switch, and turbo
LED connectors onto the corresponding
pins as shown in the figure.
( Turbo Switch )
( Turbo LED )
Break Switch Green Mode LEDReset
Speaker Power LED Keylock