System information

AMI BIOS
3-17
Tip: Because 36 bit SIMM has 4 bit more for
parity, the ECC mode can be supported by two
traditional parity SIMMs, it is no need to have
special ECC SIMM.
Chipset --> PCI 2.1 Compliant
PCI 2.1
Comliant
Disabled
Enabled
This item lets you control the Passive Release or Delayed
Transaction function of the PIIX3 chipset (Intel PCI to ISA
bridge). Enable it complies with the PCI revision 2.1. Try to
enable or disable it, if you have ISA card compatibility
problem.
Chipset --> USB Host Controller
USB Host
Controller
Disabled
Enabled
This item lets you enable or disable the USB function in
chipset. The mainboard acts as USB host, and you can plug
USB devices on the USB connector of back panel. You need
USB driver to support USB devices, normally, they are
provided by USB device vendors or operating system such
as Win95.
Important: The USB function shares INTD with
PCI slot 4. Therefore, if you enable the USB
function, only PCI cards that do not require IRQ,
such as VGA, can be installed in slot 4. The
PnP BIOS assigns an IRQ to VGA only if the
VGA requests for it.
Chipset --> USB Legacy Support
USB Legacy
Support
Disabled
Enabled
This item lets you enable or disable the USB keyboard
driver within the onboard BIOS. The keyboard driver
simulates legacy keyboard command and let you use USB
keyboard during POST or after boot if you don't have USB
driver in the operating system.
Caution: You can not use both USB driver and
USB legacy keyboard at the same time.
Disable "USB Legacy Support" if you have
USB driver in the operating system.