User Guide

Installation
Installation of a 10/100Mbps PCI bus Fast Ethernet
Card requires Hardware installation first, then BIOS
and Software installation.
Hardware Installation
1. Turn OFF the computer, unplug its power cord
and open the computer case.
2. Insert the contact edge of the 10/100Mbps PCI
bus Fast Ethernet Card into the connector of
any available PCI Bus Master expansion slot.
Press the card firmly into the connector and
ascertain that the card contacts are fully seated
in the connector.
3. For WOL model, connect the WOL cable to the
NIC WOL connector. Both ends of the WOL
cable are identical, so either and may be used.
4. Install the bracket screw, which secures the
card to the cincture chassis.
5. Replace the computer’ s case and connect the
network cable to newly installed network card.
Reconnect the computer’ s power cord and
plug it into the power outlet.
BIOS Configuration
Due to a fault in some Plug-n-Play BIOS programs,
it happens occasionally that a newly installed
adapter is assigned an Interrupt Number which is
already assigned to another device. In such a case,