User Guide

101
A
A
K
K
7
7
7
7
-
-
4
4
0
0
0
0
/
/
A
A
K
K
7
7
7
7
-
-
4
4
0
0
0
0
N
N
/
/
A
A
K
K
7
7
7
7
-
-
4
4
0
0
0
0
M
M
a
a
x
x
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
Controller" should appear.
13. Press "Next," then "Finish".
********************************************
Confirming Driver Installation in Windows 98
********************************************
To confirm that the driver has been properly loaded in Windows 98, perform the following steps:
1. Choose "Settings" from the "Start" menu.
2. Choose "Control Panel," and then double-click on the "System" icon.
3. Choose the "Device Manager" tab, and then click the "+" in front of "SCSI controllers." "Win98-ME Promise SATA150
TX2plus(tm) IDE Controller" should appear.
Windows NT 4.x Installation Guide
*********************************************************
Installing Drivers During New Windows NT 4.0 Installation
*********************************************************
1. Start the system installation by booting from the Windows NT disk:
a. Floppy install: boot the system with the Windows NT installation diskettes.
b. Floppyless install: boot from floppy and type "WINNT /B". After files have been copied, the system will reboot. On the
reboot, press the "F6" key when the message "Setup is inspecting your computer's hardware configuration…" appears.
c. CD-ROM disk install: boot from the CD-ROM disk and press "F6" key when the message "Setup is inspecting your
computer's hardware configuration…" appears.