User Guide

AK73(A)-V / AK73-V Online Manual

IDE1 is also known as the primary channel and IDE2 as the secondary channel. Each channel supports two IDE devices that

make a total of four devices. In order to work together, the two devices on each channel must be set differently to Master and

Slave mode. Either one can be the hard disk or the CDROM. The setting as master or slave mode depends on the jumper on

your IDE device, so please refer to your hard disk and CDROM manual accordingly.

Tip: For better signal quality, it is recommende

to set the far end side device to master mode

and follow the suggested sequence to install you

new device. Please refer to above diagram on

revious page.

Warning: The specification of the IDE cable is a

maximum of 46cm (18 inches), make sure your cable

does not exceed this length.