User`s manual

6
RESET
Use a pin-shaped object to reset this device to factory default settings.
Resetting the device will also reset the login password to the default.
LAN (1-4) Four RJ-45 10/100Mbps Auto-MDIX ports for connecting to either
10Mbps or 100Mbps Ethernet connections.
WAN On the 4 port broadband router, there is an RJ-45 10/100Mbps
Auto-MDIX WAN port. This port connects to your xDSL/Cable modem.
POWER Connects the supplied AC adapter to the power input jack.
1.4
System Requirements
 One or more PCs (desktop or notebook) with Ethernet interface.

TCP/IP protocol must be installed on all PCs.

Have valid Internet Access account and a DSL/Cable modem.

10/100BaseT Ethernet network cable with RJ-45 connector.

System with Microsoft Internet Explorer 6.0 or higher.
1.5
Installation Instruction
1) Power off the router and DSL/Cable modem.
2) Connect systems to the LAN ports on the router with straight Ethernet LAN cables.
3) Connect the DSL /Cable modem to the WAN port on the router.
4) Power on DSL/Cable modem firstly, wait for a minute until the modem is ready then power on
the router.
5)
Check LEDs
:
a)
Once power on the router, Power LED should be on.
b) LAN LED should be on for each active LAN connection.
c)
The WAN LE
D should be on when the DSL/C
able modem is connected.