User manual

EE400-R GigaFast Ethernet.
P 8
Lnk/Act Lnk (link): ON means LAN PC/device is connected correctly to EE400-R.
Act (activity): Blinking means there is data communication.
If the LED is continuously illuminated, it means the LAN device is successfully
connected or the port is working now.
10/100
Indicates 10 or 100Mbps wire speed corresponding to each port. (On is 100Mps)
FDX/COL
FDX (Full Duplex Mode): On means the current connection is on full
duplex mode.
COL (Collision): Blinking means the connection is experiencing collisions.
Note: infrequent collisions are normal. If the COL LED is lit too often,
there may be a problem with your connection.
1.4.2 Rear Panel
Serial
Serial port connector. It is used to connect with MODEM or console terminal
The options could be confi
g
ured via WEB browser.
(Please refer to Appendix C-2 for pin assignment & cabling)
Default
Reset to factory default settings button. Hold it down continuously about 5 seconds to
reset the hardware settings into factory default. The default LAN IP becomes
192.168.8.1.
5VDC
Where you will plug the AC-DC Power adapter.
LAN Indicators