User manual

EE400-R GigaFast Ethernet.
P 9
Chapter 2 Installation
A
ttach the power cord into the oulet first and follow the sections below to setup the WAN/LAN connection.
2.1 Hardware Connection to WAN
Connect the network cable from the Cable/ DSL modem to the WAN port of the EE400-R (Figure 2-1). If
the Link/Act light is off, check that the power and the network cable between the Cable/DSL modem and
WAN port are plu
gg
ed in correctl
y
.
(
Please refer to Appendix C for detailed cablin
g
and pin assi
g
nment
)
.
Figure 2-1 The hardware connection of WAN interface for EE400-R.
2.2 Hardware Connection to LAN
Connect the network cable from
y
our computer’s Ethernet port to one of EE400-R’s 4 LAN ports
(
Fi
g
ure 2-2
)
. If it is correctl
y
connected, the co
r
respondin
g
Link/Act li
g
ht will be lit.
Fi
g
ure 2-2 Dia
g
ram of connections between router and computers.
** If you are connecting the LAN port to another hub or switch, use a crossover RJ-45 cable.**
Once everything is connected correctly, hold down the reset button for 5 seconds to ensure that the
EE400-R is in factory default condition.