User`s manual

Chapter 5 Advanced Setup of Broadband
Router
In addition to “Setup Wizard” explained in Chapter 4 Use Your Broadband Router,
you can setup Broadband Router with more configuration options via the ”advanced
setting” page. You will enjoy Broadband Router’s high performance after activating
these advanced features.
5.1 Start from Advanced Setting
Step1. Launch a web browser on your client PC connect to Broadband Router LAN
interface and point to http://192.168.1.1 (192.168.1.1 is Broadband Router’s
default IP address.) If the router was configured with a different IP address,
use the configured address. Make sure the client PC’s IP address is in the same
subnet as the router address. Press the “Enter” key after typing the router’s IP
address. The status menu appears and shows the current system status and all
available settings.
If the main page does not pop up, please refer to 6.1 Troubleshooting in
Chapter 6 Frequent Asked Questions.
Step 2. Click the “Advanced Setup “ (see Figure 4 – 2 ) and Figure 5-1 will be
displayed ,
Step 3. The Router Status screen will show up and tell the current WAN and LAN
IP settings of your Broadband Router, including IP address, Subnet Mask,
Gateway, Primary DNS, and Secondary DNS. On the left, you will see 5
main categories, including System, Wan, LAN, NAT and Firewall.
21