User`s manual

groups

a. 10.x.x.x with subnet mask 255.0.0.0; x must be in range 0 to 255

b. 172.x.x.x with subnet mask 255.255.0.0; x must be in range 0 to 255

c. 192.168.x.x with subnet mask 255.255.255.0; x must be in range 0 to

255 or a public IP address group with appropriate subnet mask.

Click the Next button and the “DHCP Setting” page, Figure 4 – 4, appears on the

screen.

Figure 4 –4

Step 5. The ” DHCP Setting” page is used to configure DHCP Server and DHCP

Client in LAN .If DHCP Server is enabled , the LAN PC Client can

automatically obtain IP settings including IP address ,Domain Name ,Subnet

Mask , Primary DNS ,and Secondary DNS from Broadband Router .

Step 6. Click the “Finish“ button. Broadband Router will save your settings and it will

take around 20 seconds to reboot. After finishing rebooting, the page will be

redirected to the Index Page, Figure 4 - 2. Please verify if your current

network status is correct.

4.3 WAN Setup Complete

Try to use your Web browser to access a website. If you can surf the web

congratulations! Broadband Router is now operating with the factory default settings.

If you want to change the default settings, please continue reading Chapter 5

Configure Your Broadband Router.

If you could not access a website, please refer to 6.1 Troubleshooting in

Chapter 6 Frequent Asked Questions.