Assembly&Instruction Manual SKU:800-052 3 SEAT SWING BED Swing Installation Guide Save this manual for future reference
INTRODUCTION Thank you for purchasing Aoodor's Patio Swing Bed! We hope you will find joy in our products for many years to come. To ensure your personal safety during installation and to get the most out of your investment, please read this entire manual before beginning the installation process. If you feel that this process is too difficult to do on your own, we advise that you seek assistance from a local building or home improvement contractor.
Par ts Desc Qty Ref No Par ts A 2 800 - 052 - 001 B 2 C Desc Qty Ref No M 1 800 - 052 - 015 800-052-002 N 3 800-052-016 1 800-052-003 O 9 800-052-017 D 1 800-052-004 P 2 800-052-018 E 2 800-052-005 R 8 800-052-019 E1 4 800-052-006 S 12 800-052-020 F 1 800-052-007 T 2 800-052-021 G 1 800-052-008 U 2 800-052-022 H 2 800-052-009 V M6 M8 17 8 800-052-023 I 1 800-052-010 W M6 M8 17 8 800-052-024 I1 1 800-052-011 Y 2 800-052-025 J 1 800
A ssembly 1 D C Z V W P Step1:Joint the top cross beam together and fasten them by using bolt(P),washer(W),nuts(V),plastic cap(Z) 2 A B R W V Z Step2:Insert the top cross beam into the upright supports(A)(B) and fasten them by using bolt(R),washer(W), nuts(V),plastic cap(Z) 4
Assembly 3 O W F V Z G Step3:Joint the rear cross brace together and fasten them by using bolt(O),washer(W),nuts(V),plastic cap(Z) 4 V W Z O Z V W E R Step4.1:Fasten the rear cross brace to the rear upright supports by using bolt(R),washer(W) nuts(V), plastic cap(Z). 4.
Assembly 5 I I1 L S K Step5:Joint the arm(I)and(I1)with beam(K)and(L) fasten them by using bolt(S).Pay attention to the beam(L),there are two locks for locking the seat back. 6 V W Z U T J Locking the seat Step6:Assembly the seat(J) with the bed frame and fasten them by using bolt(T), plastic washer(U),washer(W),nuts(V) and plastic cap(Z) Noted:There are two latches to locking the seat to the bed frame.
Assembly 7 Z V H W S H E1 Step7.1:Assembly the tube(E1) to the arm and fasten them by using bolt(S) washer(W) nuts(V) and plastic cap(Z). 7.2:Assembly the hanging springs to the tube(E1). 8 H Step8:Hanging the seat frame onto the swing.
Assembly 9 M Y Step9:Assembly the canopy(M) to the swing using the plastic bolt(Y). 10 N Step10:Place the cushions on the bed and insert the latches to locking the bed.
Assembly 11 Step10:released the latches and insert the cushion back support to the locking system to becoming a swing chair Please don’t hesitate to contact us for any further questions, your satisfaction is guaranteed. customerservice@aoodor.com https://www.aoodor.
