Operating instructions

The air shutters are located where each burner

overlaps the oriﬁ ce that supplies it gas.

The air shutter on your main burners and sideburner

are pre-set at the factory. However, due to

atmospheric conditions and different gas pressures,

it may be necessary to adjust the air shutter for the

barbecue to light properly, obtain a proper burn,

and heat evenly.

WARNING

MAKE SURE BURNERS ARE COOL BEFORE

MAKING ADJUSTMENTS. NEVER TOUCH

A HOT BARBECUE DIRECTLY TO MAKE

ADJUSTMENTS.

After burning for at least two (2) minutes, proper air

shutter adjustment will result in ﬂ ames with short

yellow tips that appear to burn while touching the

burner ports. (Fig. 9-1).

If ﬂ ames are a lazy yellow, open the air shutters

a little at a time from the opening sizes listed in

the product data table (table1 p. 2) until the ﬂ ame

is blue with yellow tipping. It may be necessary

to use pliers to turn the air shutter. Remember to

re-tighten the air shutter adjustment screw after

adjusting the air shutter.

AIR SHUTTER ADJUSTMENT

This barbecue comes with two (2) rigid shelves, that must be attached. These can be attached using the

four support screws provided. Line up the four (4) mounting holes inside the shelf with the holes in the side

of the barbecue, and insert the screws. Tighten until snug. Detaching is a reverse process of above.

RIGID SHELF INSTALLATION

FLAME ON PORTS

FLAME OFF PORTS

Fig. 9-1 - Flame appearance diagram

SHELF SUPPORT SCREWS

View from under right shelf