Operating instructions

ManualsBrandsAOG ManualsBurnerPost barbecue patio mount

CHECKING AND CONVERTING YOUR BARBECUE

This barbecue comes from the factory conﬁ gured for

one type of gas as marked on the label behind the

barbecue face plate.

Each burner has a replaceable brass oriﬁ ce, which

must be checked during installation to verify a match

to the gas being used. When converting the barbecue

to a different gas, each burner’s oriﬁ ce must be

checked and replaced with the corresponding oriﬁ ce

for the new gas.

Consult the model speciﬁ cations table (page 2) under

the speciﬁ c gas to be burned, to determine the proper

oriﬁ ce sizes for each burner.

WARNING

HAZARDOUS OVERHEATING WILL OCCUR IF A

NATURAL GAS ORIFICE IS USED WITH PROPANE

GAS. IF YOU ARE NOT SURE THE CORRECT

ORIFICES ARE INSTALLED, OR IF AN ORIFICE

CHANGE IS NECESSARY, REFER TO THE FOLLOWING

INSTRUCTIONS.

CAUTION: Make sure the barbecue is at a safe

temperature and isolated from gas and

electrical supplies before beginning the

tasks outlined below.

Note: The cooler the barbecue, the greater the

tolerances between the stainless steel parts

and therefore the easier to disassemble and

reassemble parts of the barbecue.

For your safety, exercise caution, and make sure you have

adequate hand protection such as gloves when handling

removable sheet metal parts of the barbecue.

WARNING

THIS APPLIANCE REGULATOR IS RATED FOR

PSI MAXIMUM. IF YOUR GAS SUPPLY IS

GREATER THAN

PSI, AN ADDITIONAL REGULATOR MUST BE INSTALLED BEFORE THE

BARBECUE. SEE GAS SUPPLY REQUIREMENTS SECTION FOR PROPER GAS SUPPLY

PRESSURE

CHECKING AND CONVERTING THE REGULATOR

Note: Each end of the plastic converter is engraved with either the letters “NAT”

or “L.P.” for the respective gases. When the converter is in the cap and the

cap is held uppermost, the letters seen indicate the gas that the regulator

is set up for.

To convert the regulator from one gas to another follow steps 1-4.

STEP 2:

Remove the converter (the

plastic stalk) by carefully

pulling it away from the center

of the cap (it will snap out of

its seating).

STEP 1:

Unscrew and remove the cap from the

regulator, extracting the converter.

Barbecue regulator:

note the cap on top

STEP 3:

Turn the converter around and

replace carefully into the center

of the cap (it will snap into place).

Check that you can read the type

of gas the unit is set for.

STEP 4:

Replace the unit into the regulator

and screw down until snug.

READ GAS

TYPE HERE