Operating instructions

13
Removing/inserting main burner.
Fig. 13-1
Burner
support
Hole with
orifi ce
Burner
Clip
Burner
support
4. Using a
3
/
8
" socket, remove the orifi ce from
the valve. Access this through the hole in the
forward fi rebox plate (see PARTS LIST and
Fig. 13-1). Check the number stamped on the
face of the orifi ce (see Table 1). Repeat for
each burner as necessary.
5. If the barbecue does not have the proper
orifices installed for the gas supply you
intend to use, replace them with the correct
orifi ces. Some orifi ces were supplied with the
barbecue. They may also be obtained from the
conversion kit or supplied by your local dealer.
Note: A regulator hose will need to be connected
for conversion to propane gas.
6. After checking the
orifice drill size
or replacing the
orifice, replace
the burner over
the orifi ce fi tting,
sliding it forward,
from behind the
forward fi re wall, so the orifi ce is centered
inside the burner gas inlet, and set it gently
onto the burner support. The studs on the
bottom back of the burner must each fit
through their respective holes in the burner
support. This is critical to the safe function of
the barbecue. Finally, re-install the burner clip
(from step 3) around the burner and into the
corresponding holes in the burner support (see
Fig. 13-1).
MAIN BURNER AIR SHUTTER ADJUSTMENT
INSTALL THE FLAVOR GRIDS
Place the fl avor grids directly on the support bracket
above the burners. The panels allow heat from the
burners to be evenly distributed throughout the
cooking area. The panels are stainless steel and
will heat and cool quickly, making your barbecue
CHECKING/CONVERTING THE BURNER ORIFICES
MAIN BURNER ORIFICE SIZE CHECKING/
CONVERSION
Before beginning, make sure you have the proper
tools for the task.
This task requires:
• a #2 Phillips-head screwdriver
• a deep
3
/
8
" nut driver with a spacer (#6 nut)
Note: It may be necessary to remove the rotisserie
rod before beginning this procedure.
1. Remove cooking grids & flavor grids from the
barbecue.
2. Turn the burner valves to the OFF position.
Pull the valve knobs from their stems and
set them aside. Using a Phillips screwdriver,
unscrew the face fastener screws, (located
on the sides of the face) and remove the face
from the barbecue. Retain the screws and fi nish
washers for reattaching the face.
Note: Carefully, lift the face away from the frame.
The spark generator for the ignition system
is attached to the inside of the face panel.
The spark generator knob need not be
detached, but the wires must be unplugged
from the generator before the face is
completely removed (see Fig. 13-2).
3. Slightly pinch and remove the burner clip
(located over the rear center of the burner) from
the burner support and set aside. Then carefully
lift the burner from the burner support and out
from the hole in the forward fi re wall (see Fig.
13-1).
Fig. 13-3 - Burner orifi ce diagram
Orifi ce
Burner
Valve
Fig. 13-2
Spark generator