Operating instructions

13
oven cleaners. Some discoloring will be seen with
use. This is normal for stainless steel and does not
affect the function.
ADJUSTING YOUR BARBECUE
Important: This appliance may not light or heat
evenly or cook properly unless the
air shutters are adjusted following
installation (see AIR SHUTTER
ADJUSTMENT section).
Burner air shutters are easily accessed by removing
the front face panel. The air shutters are located on
the front portion of each burner and have a locking
screw that prevents the air shutter from inadvertent
movement (see Fig. 13-1).
T
o close or open the
air shutters, simply
loosen the locking
screw, using a long
stemmed Phillips
screwdriver, and
turn the air shutter
to open or close it.
Tighten the screws
down when the
desired setting is achieved.
AIR SHUTTER ADJUSTMENT
Light the burner to be adjusted in accordance with
the LIGHTING INSTRUCTIONS and burn for 2
minutes with the burner control knob set to HIGH
and the oven open. After burning for 2 minutes,
open the air shutter until the fl ames lift off, or appear
not to be touching the burner. Then begin closing
the air shutter until the fl ames appear to burn while
touching the burner ports (Fig. 13-2). If fl ames are
CHECKING/CONVERTING THE BURNER ORIFICES (Cont.)
a lazy yellow, open the air shutters until the fl ame
is mostly blue.
Note: Barbecues in some installations achieve a
better air/gas mixture and will ignite more
quickly if the valve is fi rst turned beyond
HIGH to MEDIUM or LOW for lighting.
BACKBURNER ORIFICE SIZE CHECKING/
CONVERSION (IF EQUIPPED)
Before beginning, make sure you have the proper
tools for the task.
This task requires:
• a
1
/
4"
nutdriver
• a
3
/
8"
wrench or socket screwdriver
Note: It may be necessary to remove the
rotisserie rod before beginning this
procedure.
1. Remove the backburner assembly as follows:
a. Remove the backburner electrode mounting
screw (
1
/
4
" hex) (see Fig. 13-3) and loosen
the electrode. Draw the wire attached to
the electrode down through the slot in the
bottom of the bracket so that the left side of
the backburner is free to be removed.
b. Remove the backburner mounting screws
(
1
/
4
" hex) located at the left end of the
backburner assembly (see Fig. 13-3).
Remove electrode and backburner mounting screws.
Fig. 13-3
Mounting screws
Electrode
Ignitor
screw
Fig. 13-1
Locking
screw
Air shutter
Fig. 13-2 - Flame appearance diagram
Flame off ports
Flame on ports