User's Manual

ManualsBrandsAODELAN ManualsAudio EquipmentWireless Microphone

User Manual

WM1 transmitter

Battery:

Use two AA batteries (number 7) for approximately 8 hours.

Key-button function：

1. Power key: long press for startup / shutdown

2. Right code key: press for 2 seconds to enter the pair code mode. Exit exit after

10 seconds.

Indicator lamp:

1. Status indicator lamp: blue color

Blue light long on: indicates the normal operating state.

Lamlight flash every 2 seconds: disconnected the transmitter from the receiver.

Blue light flashes twice every 2 seconds: indicates in the opposite code state.

2. Low-power indicator lamp:

The red light flashes every 2 seconds, indicating the battery is low.

Interface description:

MIC: 3.5mm Microphone interface, this tripole MICPHONE for external camera or

computer use

LINE IN: 3.5mm sound source interface, this is used to external LINE-IN type sound

source input such as electric ji etc.

Summary of content (4 pages)

PAGE 1
User Manual WM1 transmitter Battery: Use two AA batteries (number 7) for approximately 8 hours. Key-button function： 1. Power key: long press for startup / shutdown 2. Right code key: press for 2 seconds to enter the pair code mode. Exit exit after 10 seconds. Indicator lamp: 1. Status indicator lamp: blue color Blue light long on: indicates the normal operating state. Lamlight flash every 2 seconds: disconnected the transmitter from the receiver.
PAGE 2
WM1 Receiver Battery: Use two AA batteries (number 7) for approximately 10 hours. Key-button function: 1. Power key: long press for startup / shutdown 2, Volume + key: Volume volume by 1 unit. Long press quickly increase volume 3, Volume-key: Volume volume by 1 unit. Long press to quickly reduce the volume 4, Volume + and Volume-key press simultaneously for 2 seconds to enter opposite code mode. Exit exit after 10 seconds. Indicator lamp: 1.
PAGE 3
FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 4
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.