Service manual

Page 7 of 64
1-3-2 Input connection of PC signal
● D-SUB 15 Pin:
Connect D-SUB signal cable（VGA cable）from PC to D-SUB jack at the back of this display. And connect
earphone cable from PC earphone output jack to AUIDO input jack near to the D-SUB jack.
Setup:
Use the key “GRAPHIC” in Remote Control Transmitter or “MODE” key on Front panel controls select
source to “D-SUB” state. Then turn on the PC.
● DVI-D:
Connect DVI-D 24 Pin signal cable（TMDS cable）from equipment to DVI-D jack at the back of this
display. And connect earphone cable from equipment earphone output jack to AUIDO input jack near to the
DVI-D jack.
Setup:
Use the key “GRAPHIC” in Remote Control Transmitter or “MODE” key on Front panel controls select
source to “DVI ”state. Then turn on the equipment.
▲ Notice: The PC output can not set out of range
The highest Resolution input is 1280 X 1024 / 60Hz
Some PC models cannot be connected to the set